TAMFIS NIG LTDRC 8067447CAC ACTIVEFinima, Bonny Island, Rivers State

Earthing and Lightning Protection in the Niger Delta

Earthing and lightning protection should be designed as connected parts of an electrical installation. Installing an earth electrode, obtaining one resistance reading and filing a certificate does not establish that people, structures and connected equipment have the protection required by the design.

For a Niger Delta project, the assessment should examine the actual site: ground conditions, water exposure, corrosion, buried services, structures and connected power or communications systems. Regional assumptions are not substitutes for measurements and a site-specific design.

Separate the questions the design must answer

Protective earthing, bonding, lightning protection and surge protection have related purposes but different design considerations. The design needs to address the installation’s supply and protective arrangements as well as the paths through which lightning or induced surges may affect a structure and its contents.

IEC 60364-5-54 addresses earthing arrangements and protective conductors in low-voltage installations. The IEC 62305-1 description explains the lightning-protection series’ general scope. The applicable editions, scope limits and project requirements should be established by the responsible designer.

Do not assume one document covers every facility. Offshore installations, particular industrial systems and utility networks may require other standards and owner specifications.

Collect the information before setting a target

  • The supply arrangement, existing protection scheme and relevant equipment information.
  • Available drawings, previous test records and known modifications.
  • Site survey information, buried services and any restrictions on excavation or access.
  • Ground investigation or measurement information appropriate to the design.
  • Structural details, incoming services and the equipment that requires protection.
  • Material compatibility, corrosion exposure and practical inspection access.

A generic resistance target should not become the entire specification. Ask what engineering requirement a proposed value supports and how compliance will be demonstrated. Different systems and locations can require different assessments.

Make material selection a documented decision

Specify the conductors, electrodes, connections, supports and protective measures needed for the environment. Review compatibility at connections and the risk of damage during construction or maintenance. Describe how concealed work will be inspected and recorded before it becomes inaccessible.

For a coastal or flood-exposed site, ask how the proposed arrangement can be inspected after water exposure and how degradation will be detected. The answer should appear in the design and maintenance plan, not depend on the installer remembering where a joint was buried.

Coordinate lightning and surge protection

A protection review should consider the structure and its incoming services together. Record which party is responsible for the external protection arrangement, bonding and surge-protective measures at equipment interfaces. Avoid procuring individual devices before that coordination is resolved.

The designer should specify the intended arrangement and selection criteria. The installer then needs a clear inspection and verification plan. Purchasing a device labelled for surge protection does not establish that its placement, connections or coordination are appropriate to the installation.

Plan verification that can be repeated

Agree the test methods, acceptance criteria and safe access arrangements before construction. Record equipment identification, instrument details, measurement conditions and any limitations of the test. Measurements should be interpreted by someone competent to understand the arrangement being assessed.

Never disconnect a protective conductor or alter a live installation simply to obtain a convenient reading. Any work that changes a protection path must be assessed and controlled by the authorised site team.

A handover example

Consider a hypothetical facility extension where new equipment is connected to an existing earthing network. The construction drawing shows the new connections, but the handover pack contains only a single resistance result. A useful closeout review asks for the approved design, connection inspections, relevant verification records and updated drawings. The objective is to establish what was installed and assessed, not to collect another isolated number.

Retain that evidence as a baseline for future inspections and alterations. Link defects to locations and drawings so that subsequent maintenance can act on them.

Read our HSE planning guide and review our electrical engineering capabilities. Discuss your project with the existing drawings, installation scope and available survey records.

Prepared with AI assistance.

Tags

Keep reading

More from News

News

How to Verify an E&I Contractor in Nigeria

Verify an E&I contractor through legal identity, relevant personnel, supported technical claims, practical work controls and independently checkable evidence.

TAMFIS NIG LTD

Engineering, consulting and software from Bonny Island

Electrical and instrumentation engineering, bid preparation and consulting, IT and software.

Get in touch